TFV16 Coils - Smok | Pack x3
DTL
Pack with 3 units
TFV16 coils from Smok compatible with the TFV16 clearomizer and the TFV18 clearomizer of the same brand.
The TFV16 coils are made of nichrome Mesh, which ensures them a homogeneous and very fast heating around the fiber. Big clouds and maximum power guaranteed! 3 models are available: 0,17 ohm, 0,12 ohm and 0,15 ohm (more information below).
Offers an overhead draw (DL). It is strongly discouraged to use nicotine salts, CBD, high nicotine levels and e-liquids with low levels of vegetable glycerine (less than 70% VG).
Sold by box of 3 units.
DTL
Pack with 3 units
TFV16 coils from Smok
Buy a pack of 3 replacement TFV16 coils from Smok.
What equipment to use the TFV16 coils with?
The TFV16 coils are compatible with the TFV16 and TFV18 clearomizer of the brand Smok.
The different models of Smok TFV16 coils
The models of TFV16 coils of Smok are as follows:
- 0.17 ohm [Mesh]: air draw - Ideal at 120 watts - Ratio VG over 70% is recommended
- 0.12 ohm [Dual Mesh]: Airflow - use between 80 watts and 160 watts (Ideal at 120 watts) - VG ratio greater than 70% is recommended
- 0.15 ohm [Triple Mesh]: overhead draw - Ideal at 90 watts - VG ratio greater than 70% is recommended
The TFV16 coils are suitable for a subohm vape for optimal vapor production and vapor restitution. These can go up to 120 watts
How to use the TFV16 coils?
To change your used coil, unscrew the base of the clearomizer and remove it. Soak the new coil with a few drops of e-liquid and then place it. Finally, close the clearomizer, wait a few minutes and it's done!
Attention, it is necessary to change your coil about every 2 weeks depending on your use. Remember to replace your coil when you change flavor or you feel a burnt taste.
- Type of inhalation
- DTL
- Packaging
- Pack with 3 units
- Country of manufacture
- made in China
Free delivery from 29,90CHF purchase
Forbidden under 18 years old
If you don't smoke, don't vape
