GTi mesh coils from Vaporesso

Buy a pack of 5 replacement coils GTi mesh Vaporesso.

With what equipment to use the GTi mesh Vaporesso coils?

The GTi mesh resistors are compatible with the iTank clearomizer by Vaporesso the vaporesso Target 80 kit the vaporesso Target 100 kit the vaporesso Target 200 kit the vaporesso Gen 200 kit the kit Gen 80S of Vaporesso

The different models of Vaporesso GTi mesh coils

The models of Vaporesso GTi mesh coils are the following:

- GTi mesh coil of 0.15 ohm: aerial vape DL - to use between 75 and 90W - ratio 50PG/50VG to 20PG/80VG

- 0.20 ohm GTi mesh coil: DL aerial vape - to be used between 60 and 75W - ratio 50PG/50VG to 20PG/80VG

- 0.40 ohm GTi mesh coil: DL aerial vape - to be used between 50 and 60W - ratio 50PG/50VG to 20PG/80VG

- GTi mesh coil 0.50 ohm: air vape DL - to use between 30 and 40W - ratio 50PG/50VG to 20PG/80VG

The mesh technology promotes both the flavours and the big cloud of steam.

How to use the GTi mesh coils?

Remove the burnt coil and insert a new one. Screw the base back on. Wait a few minutes (10-15 minutes) before vaping so that the cotton present in the coil soaks up e-liquid in order not to burn your coil prematurely.

Attention, it is necessary to change your coil about every 2 weeks depending on your use. Remember to replace your coil when you change flavour or you feel a burnt taste.