Z Series replacement coils from Geek Vape. These coils are designed to accompany the must-have Zeus clearomizers and some other gear like the Obelisk 120 FC. A quick look at "complementary products" will show you the full list of compatible e-cigarettes.
Six models are available: 0.15 ohm, 0.15 ohm XM, 0.2 ohm, 0.25 ohm, 0.4 ohm and 0.4 ohm XM (more information below). The mesh technology promotes vapor production and excellent flavor rendition of your e-liquids. No doubt about it, the ideal coils for a good big subohm vape.
The XM models offer double the lifespan with no loss of flavor! Great for vapers looking for intense vapor production and impeccable, long-lasting flavor restitution.
Sold in boxes of 5 units.
Z Series coils from Geek Vape
Enthusiasts of abundant and smooth vape, rejoice! Find here packs of 5 Z Series coils for your Zeus clearomizers. With their mesh kanthal A1 technology, Z Series are at the top of their game, and that's without mentioning the XM models with their extended lifespan. Don't wait any longer, stock up now.
Coils compatible with the famous Zeus clearomizers. Check the full list of compatibilities in the "complementary products" tab.
Geek Vape's different Z Series coil models
- Z Series 0.15 ohm: very aerial DTL vape - use between 80 and 90W - ratio 50PG/50VG to 10PG/90VG
- Z Series 0.2 ohm: DTL aerial vape - use between 70 and 80W - ratio 50PG/50VG to 20PG/80VG
-Z Series 0.25 ohm (dual coil): DTL aerial vape - use between 45 and 57W - ratio 50PG/50VG to 20PG/80VG
- Z Series 0.4 ohm: DTL aerial vape with enhanced flavors - use between 50 and 60W - ratio 50PG/50VG to 20PG/80VG
Don't miss the new Z Series XM coils for longer life and always great flavors.
- Z series XM 0.15 ohm: DTL vape - use between 70 and 85W - ratio 50PG/50VG to 10PG/90VG - can accommodate double the e-liquids (60ml) without loss of flavors.
- Z Series XM 0.4 ohm: DTL vape with more flavors - use between 50 and 60W - ratio 50PG/50VG to 20PG/80VG
How to replace the Geek Vape Z coil on the Zeus subohm clearomizer?
Replacing the Z Series coil is easy. To do this, remove the base, then the damaged coil by pulling it out. Insert a new coil and put back the base. Fill and wait 10 minutes to allow the cotton to soak up the e-liquid.
Beware, you'll need to change your resistor every 2 weeks or so, depending on your usage. Remember to replace your coil when you change flavors or smell a burnt taste.
Si vous ne fumez pas, ne vapez pas
