G series coils from Geek Vape

Buy the 5 pack of G series replacement coils from Geek Vape.

With what equipment to use the G series Geek Vape coils ?

The G series coils are compatible with the aegis pod kit, the aegis pod cartridge, wenax C1 pod, Wenax C1 cartridge, Wenax Stylus pod, Wenax Stylus cartridge, the g18 Starter Pen kit, the clearomizer G18, the siren G MTL clearomizer, the g MTL tube kit.

The different models of G series coils Geek Vape

The models of G series coils are as follows:

- G series of 0.8 ohm: MTL tight vape with more vapor - use between 12 and 15W - ratio 50PG/50VG to 70PG/30VG

- G series of 1.0 ohm: tight MTL vape - to use between 10 and 12W - ratio 50PG/50VG to 80PG/20VG - compatible high nicotine, nicotine salts and CBD

- G series of 1.8 ohm (regular): very tasty MTL tight vape with very strong hit - to use between 7 and 9W - ratio 50PG/50VG to 80PG/20VG - compatible high rate of nicotine, nicotine salts and CBD

The mesh technology promotes both the cloud of steam and excellent rendering of flavors.

How to replace the coil G series Geek Vape on a pod?

To replace the coil, remove the cartridge of the pod, then the coil. Prime a new coil and place it in the slot. Fill and wait 10 minutes before vaping.

How to replace the coil G series Geek Vape on a clearomizer?

The replacement of the coil is easy. To do this, remove the base, then the damaged coil by pulling. Prime a new coil, insert it into the slot and replace the base. Fill and wait 10 minutes so that the cotton has time to soak in e-liquid.

Attention, it is necessary to change your coil about every 2 weeks depending on your use. Remember to replace your coil when you change flavor or you feel a burnt taste.