Clearomizer CE5 - Aspire Clearomizer CE5 - Aspire
- Special offer
BVC Coils (formerly BDC) Aspire compatible with the CE5 clearomizer, CE5-S clearomizer, K1 clearomizer, K1 plus clearomizer, K1 Stealth kit, K Lite clearomizer, K Lite kit, Vivi Nova clearomizer, Vivi Nova Mini clearomizer, ET-S clearomizer, Spryte pod kit, Spryte cartridge.
Dual coil positioned vertically, allowing more steam production and better rendering of e-liquid flavors.
Perfect for a tight draw MTL (indirect inhalation).
Sold by box of 5 units.
Buy a pack of 5 BVC (Bottom Vertical Coil) replacement coils. Formerly known as BDC.
The BVC coils of Aspire are compatible with the CE5 clearomizer, the CE5-S clearomizer, the K1 clearomizer, the K1 plus clearomizer, the K1 Stealth kit, the K Lite clearomizer, the K Lite kit, the Vivi Nova clearomizer, the Mini Vivi Nova clearomizer, the ET-S clearomizer, the Spryte pod kit, the Spryte cartridge.
- BVC 1.6 ohm: MTL tight draw - to use between 3.3 and 4.2 Volts - ratio 70PG/30VG - compatible high nicotine rate (0 to 18 mg), nicotine salts and CBD
- BVC 1.8 ohm: MTL tight draw - to use between 3.6 and 4.5 Volts - ratio 70PG/30VG - compatible high nicotine rate (0 to 18 mg), nicotine salts and CBD
- BVC 2.1 ohm: very tight MTL - to use between 3.7 and 4.8 Volts - ratio 70PG/30VG - compatible high nicotine rate (0 to 18 mg), nicotine salts and CBD
1. Unscrew the base containing the coil
2. Unscrew the coil Aspire BVC of the base, discard the coil
3. Simply screw a new coil on the base of the clearomizer
4. Fill your clearomizer with e-liquid (without exceeding the height of the chimney), then screw it on your battery
5. Prime the new coil as described below
6. You can vape!
When first using a coil Aspire, suck several times by plugging the air supply. This allows to soak the spray chamber to avoid a taste of burned (coil heating without e-liquid). It may be that the positive pad of the connector is pressed, which makes it impossible to electrically contact your battery with the atomizer. In this case, you just need to slightly remove the pin of the clearomizer (using a screwdriver) for it to work perfectly.
Attention, it is necessary to change your coil about every 2 weeks depending on your use. Remember to replace your coil when you change flavor or you feel a burnt taste.
Anonymous A. published the 22/08/2018 following an order made on 04/08/2018
Le migliori testine di sempre
Forbidden under 18 years old
Wishlist