Cartridges Argus air - Voopoo | Pack x2

Replacement cartridges for the Voopoo Argus air pod

Buy one or more replacement cartridges Argus air from Voopoo to switch in a flash from eliquid or change a worn out tank. This one is used only for the voopoo Argus air pod

Voopoo Argus air replacement tank, a versatile cartridge

The Argus air pod is a mTL tight drawbut also RDL. To you the clouds of steam tasty! Beyond the resistance, the versatility also comes from theairflow. But how does it work? To switch from an RDL draw to a tight MTL draw, simply remove the tank, turn the cartridge 180° and replace it

The magnetic cartridge PCTG can accommodate up to 3.8 ml of e-liquid ratio 50PG/50VG or 70PG/30VG. This is sold without coil. However, it is compatible with the voopoo PNP resistors following :

- PNP TM1 resistor 0.6 ohm (mesh): RDL vape - to use between 20 and 25W - ratio 50PG/50VG - nicotine rate less than 12 mg / ml

- PNP resistor VM4 of 0.6 ohm (mesh ): RDL vape - to be used between 20 and 28W - ratio 50PG/50VG - nicotine rate lower than 12mg/ml

- PNP Resistor R1 of 0.8 ohm: MTL tight vape with a faithful reproduction of flavors - to be used between 12 and 18W - ratio 50PG/50VG or 70PG/30VG - high nicotine rate and nicotine salts

- Resistance PNP R2 of 1.0 ohm: tight MTL vape very close to the flavors - to use between 10 and 15W - ratio 50PG/50VG or 70PG/30VG - high nicotine rate and nicotine salts

- PNP M2 resistor 0.6 ohm (mesh): RDL vape with a fairly high volume of steam - to use between 20 and 28W - ratio 50PG/50VG nicotine rate below 12mg / ml

How to use the replacement cartridge Argus air Voopoo?

The cartridge is filled from the side. Simply remove the cartridge, turn it over and remove the silicone cap. Just like filling, changing the resistor is easy. Again, remove the cartridge, pull the resistor out, prime a new coil, then place it in. After filling the tank, wait 10 minutes before vaping