Fluffi 3.5 ml Cartridges - Aspire | x2 Pack

3,5ml RDL MTL Bottom Airflow Pack of 2 units

Pack of two Fluffi cartridges, designed by Aspire and compatible with the Fluffi podmod. This pack of two cartridges lets you change flavors easily, one cartridge replacement, and you'll go from gourmet to fruity fresh eliquid in no time. You can also replace an used up cartridge. Fluffi cartridges contain mesh coils delivering excellent flavors at every inhalation. You benefit from a 3.5 ml PCTG tank to fill on the side of the cartridge.

Fluffi cartridges come in two models. Find a 1.0 ohm version delivering a tight MTL draw and a 0.6 ohm version with a more airy RDL inhalation.

Sold in packs of two.

3,5ml RDL MTL Bottom Airflow Pack of 2 units

Product Description

Aspire Fluffi replacement cartridges:

These Fluffi cartridges let you get your Fluffi podmod back on its feet. These embark mesh coils to give you excellent flavors. As the coils are integrated, once they're out of order, just replace the entire cartridge.

The Fluffi cartridges can hold a generous amount of e-liquid, with a 3.5 ml PCTG tank to fill on the side of the cartridge.

All products compatible with Fluffi cartridges can be viewed in the "complementary products" list.

How to choose your Fluffi cartridge:

There are two Fluffi cartridge models. The 1.0 ohm version delivers an MTL-type indirect-inhalation vape whose sensations are close to those of a cigarette. While the 0.6 ohm version offers RDL vaping with a more airy draw and bigger vapor production.

- Fluffi 0.6 ohm cartridge: RDL draw - to be used between 14 and 18 watts - PG/VG ratio from 50PG/50VG to 40PG/60VG - Nicotine from 0 to 12 mg/ml.

- Fluffi 1.0 ohm cartridge: Tirage MTL - to be used between 9 and 11 watts - Ratio PG/VG from 70PG/30VG to 50PG/50VG - Nicotine from 0 to 20 mg/ml, compatible with nicotine salts and CBD.

Filling the Fluffi cartridge:

Remove the protective cap.
Open the silicone tab.
Fill with e-liquid.
Close silicone tab.
Put back the protective cap.

Replace a Fluffi cartridge:

Remove protective cap.
Remove the used cartridge by pulling on it.
Clip a new cartridge in its place.
Put back the protective cap.
Caution: If the cartridge is new, allow the coil to soak in e-liquid for about ten minutes before vaping.

Attention, it is necessary to change your resistor about every 2 weeks depending on your use. Remember to replace your coil when you change flavor or smell a burnt taste.

Technical characteristics