A compact, stylish podmod

The NeXLIM GO is made to follow you anywhere with its compact size of 122 x 28.5 x 17.5 mm. It slips into a pocket with ease, while still turning heads once in hand. Choose from a range of colours and finishes to match your personal style. No screen, no buttons—just sleek simplicity, inside and out.

Simple operation

Using the NeXLIM GO couldn’t be easier. Thanks to its autodraw activation, all it takes is a puff to enjoy a smooth cloud of vapour. For settings, everything’s been designed to be intuitive—even for beginners. Just flick the switch to choose between two modes:

• ECO mode for a mellow vape that saves battery life
• Boost mode for those wanting a bit more punch in each puff

Between these modes and the different NeXLIM cartridges, you’ll be able to enjoy both airy RDL draws and tight MTL hits, depending on your mood.

You can fine-tune the draw even further using the adjustable airflow for a personalised vaping experience.

A battery built to last

OXVA didn’t hold back on battery life. The 1800 mAh built-in battery offers generous sessions between charges. A handy LED lets you keep track of the battery level at a glance:

• Green: 100% to 65%
• Blue: 65% to 30%
• Red: 30% to 0%

Once it hits red, just plug it in via the USB-C 5V/2A port—a full charge takes only 45 minutes. Please note: the charging cable is not included.

Dual mesh coils for outstanding flavour

The NeXLIM GO works with NeXLIM cartridges, and you’re in for a treat. These 4 ml pods come with dual mesh coils for even heating, exceptional flavour clarity and extended coil life.

This kit includes the 0.8 ohm version, perfect for a loose MTL draw with a good amount of vapour and a balanced experience.

• NeXLIM 0.8 ohm cartridge: Loose MTL – 16W ECO mode / 30W BOOST mode – PG/VG ratios from 60/40 to 40/60 – recommended nicotine up to 12 mg/ml.

Looking for bigger clouds or a tighter draw? NeXLIM cartridges are also available in 0.6 ohm and 1.2 ohm on Freevap.

How to use NeXLIM cartridges

Side fill system

• No need to remove the cartridge from the battery—handy.
• Open the silicone tab on the side of the pod.
• Fill it with your favourite e-liquid.
• Close the tab firmly.

Replacing the cartridge

• Pull out the used cartridge.
• Clip in a new one.
• Important: If the coil is brand new, make sure to prime it by letting it soak in e-liquid for 10 minutes before vaping. If you notice reduced flavour or a burnt taste, it’s time to swap your pod.

What’s in the NeXLIM GO Kit?

• 1 x NeXLIM GO pod
• 1 x NeXLIM 0.8 ohm cartridge
• 1 x User manual