Xros Cartridges 3 ml - Vaporesso | x4 Pack

Xros 3 ml replacement cartridges by Vaporesso:

Fill up on cartridges with this pack of four Xros cartridges, which now feature a 3 ml reservoir as well as a wide variety of coils to satisfy a wide range of vapers. The coils have been given Vaporesso's Corex treatment to bring you even more flavour and longer cartridge life. The tank features SSS technology to ensure leak-free vaping.

With what equipment to use the Xros 3 ml cartridge?

The Xros 3 ml cartridges are compatible with all pods in the Xros range by Vaporesso. Find compatible products under the “complementary products” tab.

4 versions of the Vaporesso Xros 3 ml cartridge:

• Xros 3 ml 0.40 ohm cartridge: RDL draw - 20W to 30W - ratio 50PG/50VG to 30PG/70VG - Nicotine content up to 6 mg/ml (only compatible with the Xros Pro pod).
• Xros 3 ml 0.60 ohm cartridge: RDL draw - ratio 50PG/50VG to 40PG/60VG - Nicotine rate up to 12 mg/ml.
• Xros 3 ml 0.70 ohm cartridge: RDL draw - ratio 60PG/40VG to 40PG/60VG - Nicotine rate up to 12 mg/ml.
• Xros 3 ml 0.80 ohm cartridge: MTL draw - ratio 70PG/30VG to 50PG/50VG - Nicotine rate up to 20 mg/ml.

How to fill your Xros 3 ml cartridge:

• Remove the cartridge from the battery.
• Open the silicone tab, fill, and then close.
• Put back the cartridge on the battery.

Top fill Xros 3 ml 0.4 ohm cartridge:

• Unclip the drip tip.
• Fill with e-liquid.
• Put the drip tip back on.

How to replace your Xros cartridge:

• Remove the used cartridge.
• Place a new cartridge in its place.
• Caution: If the coil is new, prime it well by letting it soak in e-liquid for 10 minutes before vaping.

Attention, it is necessary to change your cartridge about every two weeks, depending on your use. Remember to replace your coil when you change flavour or smell a burnt taste.