Cartridges Klypse - Innokin | Pack x3

2ml MTL Pack with 3 units

New versions

Innokin Klypse cartridges compatible with Klypse pods. As the name suggests, this replacement cartridge clips onto your ecig, making it easy to change e-liquid in a flash! Are you nearing the end of your tank and/or resistor life? This cartridge replaces a worn-out tank or burnt coil. Be careful, if your coil is damaged, you'll need to change the whole cartridge.

This 2 ml PCTG magnet cartridge gives you a tasty MTL draw. Best of all, you can use nicotine salts, CBD and high nicotine levels. Two versions are available: 0.8 ohm mesh and 1.2 ohm mesh (more information below). Choose a PG/VG ratio of 50/50 to 80/20. Filling is on the side.

Sold in packs of 3.

2ml MTL Pack with 3 units

Product Description

Klypse replacement cartridges from Innokin

The 3-pack of Klypse cartridges lets you switch e-liquids as fast as the speed of light, so you can vary the pleasures you enjoy. This tank will replace a worn cartridge or coil. The coil is directly integrated into the tank, so it's the whole cartridge that needs changing when the coil is damaged. The ultimate tip? Stock up on cartridges so you're always ready to vape with your pod!

What equipment should I use the Klypse replacement cartridge with?

The Innokin Klypse cartridge is compatible with :

- Klypse pod

- Klypse Zip pod

2 versions of the Innokin Klypse cartridge are available

The Innokin Klypse cartridge models are as follows:

- Klypse 0.8 ohm cartridge (Mesh): tight MTL vape (satisfying vapor rich in flavor) - ratio 50PG/50VG to 80PG/20VG - compatible with nicotine salts and high nicotine levels.

- Klypse 1.2 ohm cartridge (Mesh): MTL tight draw - ratio 50PG/50VG to 80PG/20VG - compatible with nicotine salts, CBD and high nicotine levels.

How to refill your Innokin Klypse cartridge:

Remove the cartridge from the pod.
Open the silicone tab and fill with e-liquid.
Close the tab and replace the cartridge in the pod.
If the cartridge is new, let the coil soak for ten minutes in a full tank before vaping.

How to replace the Klypse Innokin cartridge :

Remove the cartridge from the pod.
Clip on a new cartridge in its place, using the easy peasy magnet system.

Please note that you need to change your cartridge every 2 weeks or so, depending on your usage. Remember to replace your coil when you change flavor or smell a burnt taste.

Technical characteristics