TMD Coils - BP Mods | 5x Pack

DTL RDL MTL Pack with 5 units

The TMD coils of BP Mods are ready to bring vapor and flavour to the Lightsaber S and Lightsaber L kits, but also to clearomizers and cartridges compatible with PNP Voopoo and GTX Vaporesso coils.

The manufacturer BP Mods has done a great job on these coils that will bring an excellent flavour rendering. 4 models are available in a wide variety of ohmage, so there is a TMD resistor for all vapers whether you are addicted to an MTL, DL or RDL draw.

Sold in boxes of 5 units.

DTL RDL MTL Pack with 5 units

Product Description

BP Mods TMD coils

Get now the TMD coils of BP Mods to bring the best flavours to your kit Lightsaber S, Lightsaber L or any other clearomizer and cartridges compatible with PNP coils from Voopoo and GTX coils from Vaporesso.

The different models of TMD resistors from BP Mods

Find 4 models of TMD coils that will delight MTL, RDL and DL lovers.

- Coil TMD Pro 0.55 ohm: RDL draw - to be used between 28 and 35 watts - ratio 50PG/50VG to 30PG/70VG.

- Coil TMD Pro 1.05 ohm: MTL draw - use between 10 and 13 watts - ratio 70PG/30VG to 50PG/50VG. Compatible with liquids with nicotine salts, CBD and high nicotine content.

- Coil TMD Mesh 0.30 ohm: DL draw - to use between 45 and 55 watts - ratio 50PG/50VG to 20PG/80VG.

- Coil TMD Mesh 0.80 ohm: RDL/MTL draw - use between 18 and 28 watts - ratio 50PG/50VG to 30PG/70VG. Compatible with liquids with nicotine salts, CBD and high nicotine content.

How to use TMD BP Mods ?

Once unpacked, soak the cotton of the TMD coil, then, the coil will simply slip into the base of your cartridge or your clearomizer after unscrewing the base of the latter.

Put everything back in place, if necessary, fill your tank with liquid and wait about ten minutes. You are ready for a rich and tasty vape.

Attention, it is necessary to change your coil about every 2 weeks depending on your use. Remember to replace your coil when you change flavour or if you feel a burnt taste.

Technical characteristics