A simple design with a colourful look

The Vibe SE pod is simple yet fun. Its slim, compact size(115.9 x 26.6 x 17.6 mm, 50 g) fits in any pocket, while its smooth coating makes it a pleasure to hold every day.

When it comes to colours, Vaporesso hasn't cut any corners, offering options that won't go unnoticed. If you prefer to keep a low profile, don't panic, there are still two colours to suit you perfectly.

Vary the pleasures with a flick of the

wrist

The Vibe SE pod has two modes of use: ECO to save battery life and prolong the life of your coil, and PWR for a little more kick and a denser vapour. Switch from one mode to the other using a small switch. The chipset intelligently adjusts the power according to the cartridge installed, for perfectly calibrated vaping without having to think. Activation is automatic on inhalation(auto-draw), so there's no need to bother with buttons.

A battery that keeps up

With its built-in 1100 mAh battery, the Vibe SE has plenty of battery life to keep you going all day, or even longer if you're not too quick on the uptake. Charging is via a 5V/1A USB-C port on the side of the pod. An LED indicator shows the battery status at a glance.

• Green from 100% to 70%.
• Blue from 70% to 30%.
• Red from 30% to 0%.

Please note: the Vibe SE kit does not include a charging cable. If you've got one lying around the house, we've got just what you need at Freevap.

Savour every puff with Vibe cartridges

The pod comes with a 4.5 ml cartridge, a particularly generous reservoir to avoid frequent refills. Vibe cartridges are fitted with Dual Mesh coils (non-replaceable), giving you amazing flavours. In this kit, you'll find the 0.6 ohm / 0.8 ohm version (0.6 ohm in PWR mode and 0.8 ohm in ECO mode), a cartridge that delivers a good dose of vapour.

• Vibe 0.6 ohm / 0.8 ohm: MTL/RDL draw - ECO 14W (0.8 ohm) PWR 24W (0.6 ohm) - 50/50 PG/VG ratio - recommended nicotine levels up to 12 mg/ml.

Looking for an MTL experience with a tighter draw? Find the 0.7 ohm / 1.0 ohm version on Freevap (sold separately).

Using Vibe cartridges

Filling the cartridge

• Remove the cartridge from the battery.
• Open the tab on the side of the tank.
• Fill with your favourite e-liquid.
• Close the tab again.

Replacing the cartridge

• Remove the cartridge with the used coil.
• Install a new cartridge.
• Warning: If your coil is new, prime it well by letting it soak in e-liquid for 10 minutes before vaping. If you feel a reduction in flavour or a burnt taste, it's time to replace your cartridge. If you notice a reduction in flavour or a burnt taste, it's time to replace your cartridge.

Contents of the Vibe SE kit by Vaporesso:

• 1 Vibe SE pod
• 1 Vibe 0.6/0.8 ohm cartridge
• 1 user manual