Pod Doric 60W - Voopoo

Vape discreetly with the Doric 60W pod from Voopoo

The Doric 60W tubular ecig joins the pod family with its compact size, light weight and ease of use. The Doric offers a DL draw. However, it can also offer a tight MTL draw with the other PNP coils not included. For those who are familiar with the Drag, you will find the PNP cartridge.

The design of the electronic cigarette Doric 60 by Voopoo

The Doric is no exception! Made of aluminum alloy, it too is compact (113.45 mm in height and 26.55 mm in diameter) and lightweight. Below the battery, you find a non-slip circle so that your vape does not slip when you put it upright.

Its ergonomic tubular shape promotes an exceptional grip.

The pod Doric 60 Voopoo: An air draw DL

The Doric pod comes with 2 PNP coils:

- PnP-VM5 Mesh 0.2 ohm: tasty air vape - To be used between 40 and 60 watts - Ratio 30PG/70VG to 20PG/80VG - Nicotine content less than 6mg / ml

- PnP-VM1 Mesh 0.3 Ohm: tasty air vape (less vapor than the 0.2 ohm version) - To be used between 32 and 40 watts - Ratio 30PG/70VG to 20PG/80VG - Low nicotine levels

The mesh technology promotes both the flavors and the production of steam. This ecig offers an air draw DL for large clouds of tasty steam. However, with other PNP coils (not included)you get a tighter draw MTL. This vape is therefore compatible with all pNP coils except VM6 of 0.15 ohm

The change of coil is very simple with a pull-and-push system. Just pull on the used coil, prime the new one and push it into the slot. Before vaping, wait 10 minutes.

Be careful, it is necessary to change your coil about every 2 weeks depending on your use. Remember to replace your coil when you change flavor or you feel a burnt taste.

Via the adjustable airflow ring, switch from an air draw to a tighter one.

The ease of use of the ecigarette Voopoo Doric 60

On the Doric, you find a single button: the switch (fire button). The use is ultra simple! Either you vape by pressing the switch, or only by sucking

The power of the Doric goes from 5 to 60W. 3 power modes are at your disposal. The setting is done via 3 clicks on the switch. And the power setting is indicated by a color LED (just above the switch). The GENE.TT chipset provides all the necessary protection in case of short circuit, overload, overheating and excessive discharge.

The charge level of the built-in 2500 mAh battery is also indicated by the LED color. Quickly charge your pod with the supplied USB-C cable (max charge current 1.6A)

Even the pNP cartridge 4.5 ml PCTG is easy to use. Filling is done from the bottom. To do this, remove the battery cartridge and then the silicone cap.

Here is what you get:

- 1 pod Doric 60

- 1 PNP cartridge of 4.5 ml

- 1 PNP coil VM5 of 0.2 ohm

- 1 PNP coil VM1 of 0.3 ohm

- 1 USB-C cable

- 1 user manual

The characteristics of the pod Doric 60 Voopoo :

- Dimensions: 113.45 mm height x 26.55 mm diameter