Deck BP RBA - Aspire

Rebuildable RBA base for Aspire BP80, BP60, Finixx and Onixx kit

The RBA base is a rebuildable single-coil tray that allows you to convert your BP80, BP60, the nautilus prime X cartridgethe finixx kit or your onixx kit into a real rebuildable material. Very easy to use, it is intended for people wanting to start rebuildable or vapoteurs already experienced who will appreciate the speed of design

With this tray, you can find a real balance of vape between flavors and smoke volume depending on your setup.

Switching to the RBA tray is also synonymous with savings, because it is possible to change the coil and cotton at lower cost.

How to change your resistance BP RBA on your pod?

There are 2 solutions to mount the resistor via the BP RBA plate:

• Use fine resistive wire
• Use prefabricated coils for electronic cigarette

It is important to note that for rebuildable pod, you can not use large coils operating at 200W.

After making or retrieving your prefabricated coil, cut the legs of it to the right height and then install the coil in the RBA base.

You can now fix them with the screwdriver and the 2 small screws to block the legs. It's time to add the rebuildable cotton to the mono-coil and insert it into the 2 slots. It is important to aerate your cotton to obtain a better capillarity of the liquid.

Now soak your cotton with the liquid and wait a few minutes. You can now insert your tray in the tank of your pod and start vaping after filling your tank.

No worries, if you do not want to switch to rebuildable, it is possible to buy BP Aspireresistors.

The RBA base comes with:

- 1* RBA BP tray

- 1* Pin 510 adapter

- 1* Pre-assembled mono-coil (without cotton)

- 2* Small screw

- 2 O-rings

- 1* Small screwdriver